COMPLETING OF THE WORK
BEFORE
On the needles, dial 92 (100) 108 loops and knit 2 cm = 6 rows of garter stitch for a slat.
To continue the work of the front satin stitch, while already in the 3rd row from the plank, begin to perform decorative decrements to be fitted. To do this, distribute the loops in the following way: edge, 29 (31) 33 face, 2 knit loops with a tilt to the left, 28 (32) 36 face, 2 loops knit together the front, 29 (31) 33 front, edge.
These reductions will be repeated 5 more times in every 6th row, the number of loops between the reductions in each row in which they are performed will decrease by 2 loops.
After 14 cm = 40 rows from the plank, the slack loops begin to add again. To do this, distribute the loops as follows: edge, 29 (31) 33 face, pull out 1 crossed face loop from the broach, 20 front face loops, pull out 1 crossed face loop, 29 (31) 33 front, loop edge.
Repeat these reductions 5 more times in every 6th row (5 times in every 6th row) 5 times alternately in every 4th and 6th row, the number of loops between increments will increase in each row in which they are performed, on 2 loops. After the last row in which the increments are made, the initial number of loops will be again reached - 92 (100) 108.
After 29 cm = 84 rows (27 cm = 78 rows) 25 cm = 72 rows from the strap for armholes, close 5 loops from the right edge and 5 loops in the next purl from the left edge.
Then, in each 2nd row (= in each front row) for raglan bevels on both sides, underline 25 (28) 31 times in 1 loop. At the same time from the right edge after edge trim perform, tying 2 loops with a slope to the left, and from the left edge in front of the edge 2 loops knit together the front one.
After 45 cm = 130 rows from the strip for the neckline averages 22 (24) 26 loops left and finish both sides separately.
Along the edge of the neckline and for rounding the cut-out in each 2nd row, close 1 time 2 loops and 1 time 1 loop.
After 47 cm = 136 rows from the plank, close the remaining 2 loops.
BACK
Knit, as before, but with a cut. To do this, after 41 cm = 118 rows from the plank, divide the work in the middle and finish both sides separately. The last loop from the cut edge is knit as edging. At the same time, first finish the right side of the back with raglan cuts along the right edge, as described above, and after 49 cm = 142 rows from the plank, leave the remaining 13 (14) 15 loops.
Then add the left side of the backrest to the end.
ASSEMBLY
Secure the thread. Stretch all the details according to the pattern, slightly moisten and leave to dry. Make the seams with mattress stitching.
For the neckline, dial and add the loops as follows: start with a cut on the left side of the back and transfer into 15 circular needles 13 (14) 15 pending loops, then additionally dial 13 loops for the connecting web between the front and back, along the edge with closed loops of the neckline dial 6 loops, then transfer to the circular needles 22 (24) 26 deferred loops of the front side of the neckline, around the edge with closed loops of the neckline, collect 6 loops, then for the connecting lintel leading from the front to the back, again Set 13 loops and then transfer to the circular needles 13 (14) 15 pending loops of the right side of the back = 86 (90) 94 loops. Now on all the loops knit 3.5 cm = 12 rows of elastic, in the 12th row all loops close on the pattern.
Armholes crochet 1 beside crochet stitches.
Crochet the cut 1 with a number of single crochets, while on the right side of the back, make 2 hinged buttonholes.
Start from the right edge of the cut and tie each edge of the cut to a crochet by making for each edge about 15 posts with no crochet. First, after the 1 st column, without a single crochet, make the first hinged loop.
Photo: magazine Sabrina. Special issue »№3 / 2017