Click For Crochet Abbreviations List

An interesting embossed pattern on this jumper is formed by semi-patent loops. The rounded line of the bottom of the front and back also looks attractive, as a result of which the level of the side of the model is slightly raised.
Dimensions
S / M (M / L) L / XL 
Width of the product on chest girth: 93 (103) 113 cm 
Product length: approx. 58 (60) 62 cm



You will need
Yarn (96% alpaca wool, 4% nylon; 50 g / 110 m) - 8 (9) 10 skeins gray-beige melange; Knitting needles number 5; circular needles number 4.5 with a length of 40 cm.



Patterns

Elastic
Knit alternately 1 out., 1 persons.



3 p. Knit together the front with a slope to the left (in the outside. Number)
3 n. (Face. Noose loop, 1 w., Face. Nakida loop) to remove, as with the front knitting, on the right knitting needle, then return to the left knit and knit together the front one.



3 p. Knit together the front (in the outside. Number)
Tie the 1st paragraph (face. Loop with crochet) face and the next 2 paragraph (1 out., Face. Loop with crochet) stretch through the knit.



1 increase (in the internal series)
From 1 p. Knit 3 p. = Of persons. crochet loops knit: 1 person., 1 out., 1 person.



Semi-patent pattern
1st row (= face. Row): 1 face., * Make 1 knit on the knitting needle and remove the next loop, 1 face. *, Repeat from * to * to the end of the row. 

2nd row (= izn. Row): 1 person., * Loop and nakid knit together front, 1 izn. *, Repeat from * to *, finish: loop and nakid knit together facial, 1 person. 

Repeat these 2 p. until the end of the work.



Attention!
That side, which is usually considered the seamy side of a semi-patent pattern, will be the front side of the product.



Knitting density
16 p. X 28 p. = 10 x 10 cm, connected with a semi-patent pattern on the needles No. 5.



Important!
The density of knitting must match the given. Therefore, before starting to work, you should tie a pattern sample: dial 27 points and knit 14 cm with a semi-patent pattern. Then count the loops on the middle section of the fabricated sample with a length of 10 cm: if there is more than 16 points in this segment, change the spokes to thicker ones, if less - to thinner ones. It is important that the density of your knitting corresponds to a given density, first of all - in width. If the instruction contains only one number, then it applies to all sizes.



Completing of the work

Back
On the needles number 5 dial 75 (83) 91 p. And knit with an elastic band (1st p. = Wear. Row), start and finish 1 wear. 

After 3 p. work to continue with a semi-patent pattern. 

When the length of the part is 5 cm (finish face. Next), on an average 65 p. Knit with a figured semi-patent pattern (= semi-patent pattern with offset loops).



Attention!
Loops to shift in izn. ranks! 

1st row of the pattern: 7 (11) 15 p. Knit with a semi-patent pattern, on the next persons. loop, make 1 increase, 9 p. knit with a semi-patent pattern, 3 s. knit together the front with a tilt to the left, knit to the last 20 (24) 28 s. row, 3 s. knit together the front, 9 s. individuals. loop to make 1 increase, 7 (11) 15 p. knit with a semi-patent pattern. 

Then run 3 p. semi-patent pattern.

2nd row of the pattern: 9 (13) 17 p. Knit with a semi-patent pattern, on the next persons. loop, make 1 increase, 9 p., knit with a semi-patent pattern, 3 p., knit together the front with a tilt to the left, knit to the last 22 (26) 30 p. rows, 3 p., knit together the front, 9 p. individuals. loop to make 1 increase, 9 (13) 17 p. knit with a semi-patent pattern. 

Run 3 p. semi-patent pattern. 

Continue to move the loops to the middle in every 4th p. (= with each row in which the loops will be displaced, in the middle there will be less than 4 points, and on both sides more than 2 points). 

When in the middle there will be 9 p., Tie 9 p. with a semi-patent pattern and again start moving the loops from the 1st p. pattern.

After the last row with an offset perform 9 p. with a semi-patent pattern and start shifting the loops for the third (last) time. 

When will all the rows be completed with an offset (= 3 times), simultaneously with the 4th p. with offset in ex. A row to start ragland increments: 5 knit with a semi-patent pattern, 3 sm. knit together the front with a tilt to the left, then knit with a semi-patent pattern to the last 8 sm. 

Regular reductions are to be repeated in every 4th p., Until 21 p. 

Remain on the needles. After the last row with the reductions, tie another 3 p. and close the loop (= straight edge of the neck.)



Before
Knit as back, but with a deeper neck. To do this, when the needles after the Raglian downs remain 45 (47) 49 p., Knit 1 p. after the last row with cuts, the average 17 (19) 21 c. close and finish both sides separately, continuing the reglan cuts. 

To round the neck, close the inner edge at the beginning of each row 2 times in 4 points. 

Close the remaining loops in the same row. 

The second side finish symmetrically.



Right sleeve
On needles No. 5, dial 43 (47) 51 points and knit with an elastic band (1st p. = Wear row), begin and finish 1 wear. 

After 3 p. continue to work with a semi-patent pattern. 

When the length of the part is 12 (10) 12 cm, add on both sides (after / in front of the chrome loop) for the bevels in each 8 (8) 6th p. 1 p., until the spokes are 63 (71) 79 p. 

When the sleeve length is 43 (44) 45 cm, start the slow down subracks and execute them the same way as on the back. 

When the needles will be 19 p. And will be connected 3 p. after the last row with cuts, close the loops for the upper bevel (continuing to carry out ragland cuts, but now only at the end of the row): at the beginning of each person. rows 4 times 3 p. 

The following persons. row close the remaining hinges.



Left sleeve
Knit symmetrically to the right sleeve (close the loops for the upper bevel in the outer rows, starting one row earlier).



Assembly
Sew parts from the front side of the mattress seam = longitudinal edges of the parts (= 1 p. X 1 p.). 

Run side seams, seams of sleeves and seamed seams. 

Bake 
On the circular needles number 4.5 dial on the edge of the neckline on the front side of the loop (thread at work). Start from the right rear raglan seam and dial 1 p. From each closed loop + 1 p. On raglan seams. Knit in a circle with a rubber band. Through 3.5 cm loop close on the picture. 

Photo: magazine “Burda. Creazion »№1 / 2018

Source