Click For Crochet Abbreviations List
DIMENSIONS
Uniform size
YOU WILL NEED
Yarn (100% cotton; 70 m / 50 g) - 800 g color rosewood; Spokes number 5,5; circular needles № 4,5; hook number 4.
ELASTIC
Rows in the forward and reverse direction (the number of loops is a multiple of 4 + 2 edging). Each row start and finish 1 edge.
Facial rows: * 1 facial, 2 purl, 1 facial, from * constantly repeat.
Purl rows: knit loops on the picture.
Circular rows (the number of loops is a multiple of 4) = alternately 2 face, 2 purl.
SEMI-PATIENT PATTERN
Odd number of loops. Each row start and finish 1 edge.
Facial rows: * 1 purl, 1 facial, with the introduction of the needle 1 row lower, from * constantly repeat, finish 1 purl;
purl rows: 1 face, 1 purl, from * constantly repeat, finish 1 face.
The following patterns are related to the diagram: for clarity, the last front row of the elastic is given, respectively (= row 0 of the pattern) and all the following front rows. In the purl rows of the loop knit by drawing. The above loop to perform in width 1 time.
PATTERN FROM “KOS” A
First 13 loops = knit acc. Scheme 1 A. Run the 1st to the 10th rows once, then constantly repeat the 3rd to the 10th rows. After the 1st row, 18 p.
Will remain on the knitting needles.
Initially, 13 loops = knit, like a pattern from “braids” A, but according to 1 B.
CENTRAL PATTERN ON 30 DOORS
Knit acc. Scheme 2. Constantly repeat the 1st–46th rows.
KNITTING DENSITY
18 p. X 20 p. = 10 x 10 cm, connected by patterns of "braids" and the central pattern;
13.5 p. X 24.5 p. = 10 x 10 cm, connected with a semi-patent pattern.
ATTENTION!
The poncho consists of 2 separately connected middle and side parts, respectively.
Pattern
COMPLETING OF THE WORK
MIDDLE (2 DETAILS)
Dial 58 loops with a cross set into the spokes and tie 5 cm = 10 rows for the strap with a rubber band.
Continue the work as follows: edge, 13 p. Pattern of "braids" A, 30 p. Of central pattern, 13 p. Pattern of "braids" B, edge.
After the 1st row on the needles will be 68 loops.
After 50 cm = 100 rows from the plank, close all loops.
SIDE PART (2 DETAILS)
Набрать на спицы 154 петли крестообразным набором и для планки связать 5 см = 9 рядов резинкой, а также 1 изнаночный ряд изнаночными, при этом в последнем изнаночном ряду прибавить 1 п. = 155 п.
Продолжить работу полупатентным узором.
Одновременно убавить для бокового скоса с обеих сторон попеременно в каждом 4-м и 2-м ряду от планки 33 x 2 п. следующим образом: по правому краю начать с 1 кромочной, 1 изнаночная, 3 петли провязать вместе протяжкой (1 петлю снять, как лицевую, 2 петли провязать вместе лицевой, затем протянуть ее через снятую петлю); по левому краю вязать до последних 5 петель, затем 3 петли провязать вместе лицевой, 1 изнаночная, кромочная.
Через 41 см = 100 рядов от планки закрыть оставшиеся 23 п.
СБОРКА
Side parts to connect with the middle parts.
Tie the neck edge with 1 roundabout near conn. Art., while for stability skip every 2nd loop.
For slats dial on the circular needles from Comm. Art. 88 loops and knit elastic. With a width of 5 cm, close all hinges according to the pattern.
Photo: magazine "Sabrina" №8 / 2016