Stylish elongated jumper is a harmonious union of patent patterns and embossed "braids", so it is very soft, plastic and unusually warm.
Yarn (45% sheep wool, 45% polyacryl, 10% alpaca wool; approx. 115 m / 50 g) - approx. 500 g rosewood color; Knitting needles № 4,5 and 5; circular needles number 4.5, length 80 cm
Knit according to the above scheme. Distribute loops according to the instructions. In height, perform 1 x 1st and 2nd rows, then repeat from 3rd to 12th row.
REDUCED BURNERS FOR BACK AND TRANSIT
Along the right edge: chrome., 3 s. Knit along with a tilt to the left (= 1 s. Remove, as in the case of knitting, stretch the 2 faces and remove the loop through the knitted ones);
on the left: 3 p. knit together the front, chrome.
When performing subtracts, make sure that the nakida are always compensated by loops tied together.
REDUCED HOSE PACKAGES
Align right: chrome., 2 p. Knit together purl;
on the left: 2 p. knit together purl, chrome.
When performing subtracts, make sure that the nakida are always compensated by loops tied together.
KNITTING DENSITY
18 p. X 24 p. = 10 x 10 cm, a fragment of the pattern on 10 s. Between the arrows a and b with the spokes No. 5;
20 cm = the middle fragment of the pattern between the arrows b and c spokes №5.
Pattern
COMPLETING OF THE WORK
BACK
Dial on the needles No. 4,5 125 loops and, starting with the inside. Row and 1 out. loop, tie 6 p. = 3 cm elastic.
To continue the work with knitting needles No. 5 in relief patterns, distributing the loops as follows: chrome., A fragment of the pattern at 10 points between arrows a and b, perform 4 х, 42 points between arrows b and c, a fragment of the pattern at 10 points between arrows a b to perform 4 x, finish 2 points after the arrow d.
For ragland bevels at a height of 25 cm = 60 p. from the gum to reduce on both sides 1 x 4 p., in each of the following 2nd p. 1 x 2 p. And in each 4th p. 11 x 2 p. = 45 p.
Through 25 cm = 60 p. from the start of the raglan bevels, temporarily leave the remaining loops.
BEFORE
Knit as back.
SLEEVES
On the needles №4,5 dial 81 loop and tie 6 p. = 3 cm elastic, while after chrome. start with izn. loops.
To continue the work with the needles No. 5, distributing the loops in the following sequence: chrome., A fragment of the pattern on 8 points between arrows e and b, 10 points between arrows a and b, 42 points between arrows b and c, 10 points between arrows c and d, 9 points between arrows c and f, chrome.
Through 60 r. = 25 cm from the gum to lower on both sides for raglan bevels 1 x 3 p., Next 2 r. 1 x 1 p., Then in every 2nd p. another 14 x 1 p. = 45 p.
At a height of 25 cm = 60 p. from the start of the raglan bevels, temporarily leave the remaining loops.
ASSEMBLY
For the bei, transfer the consecutively left loops of the parts to circular needles: 45 p. Of the left sleeve, front, right sleeve and back = 180 p. And knit in circular rows.
Knit 1 p. front, while alternately every 2nd + 3rd loops and every 4th + 5th loop to knit together with front loops = 130 p.
Perform another 7 circles. = 3 cm rubber band and close the loop on the figure.
Run seams, sleeve seams and side seams.