Bertie

MINI TULIPS WITH FRIFORM PETALS

Click For Crochet Abbreviations List

Tulips 
We need: 

Hook No. 1.1 
yarn: 
iris, CRYSTAL (100% acrylic) 275 m. / 50 g. 
Needle for stitching; 
Scissors; 
Filler; 
For fastener No. 1: 
ready-made loop (usually comes in a pair with a hook) 
For fastener No. 2: 
glue, clip, button, adhesive plaster on a fabric basis 
On request: 
key ring or key ring, snap hook for key chains, etc. 

Flower height - 5 cm, diameter - 4 cm. 



Legend: 
vp - air loop; 
SBN - single crochet; 
pr - increase: 2 columns without nakid in one loop: 
kill - decrease: 2 columns without nakid together; 
ss - connecting stub.

Bud: 




Fit in a spiral. Fill in the course of knitting. 
1 row: 6 sbn in the ring amigurumi = 6 sbn * 
2 row: (ave) x 6 times = 12 sbn 
3 row: (ave, 1 sbn) x 6 times = 18 sbn 
4 row: (ave, 2 sbn) x 6 times = 24 sat 
5 row: (pr, 3 bun) x 6 times = 30 sat 
6 row: (pr, 4 bun) x 6 times = 36 bun. ** 
7-12 rows: 36 Sat 
13 row: (10 Ub, K) x 3 times = 33 Ub 
14 row: (9 Ub, ub) x 3 times = 30 Ub 
15 row: (8 Ub, u) x 3 times = 27 sat 
16 rows: (7 sat, ub) x 3 times = 24 sat 
17 row: (6 sat, ub) x 3 times = 21 sat 
18 row: (5 sat, ub) x 3 times = 18 sat. 
19 row: (4 sbn, ub) x 3 times = 15 sbn 
20 row: (3 sbn, ub) x 3 times = 12 sbn
21 row: (2 sbn, ub) x 3 times = 9 sbn 
22 row: (1 sbn, ub) x 3 times = 6 sbn Pull 
loops. Finish knitting. Thread trim and thread inside. 

* if we conceive a tulip as a keychain, then after the 1st row we insert an eyelet (from a clothes hook) 








** if there is no ready eyelet on hand, then we can make it from a clip or a piece of wire. Straighten the scrapie or wire, grease it with glue and tightly wrap it with a green thread in the middle about 2 cm in length. Let it dry. 




Bend in half, leaving the wrapped portion rounded. Insert both ends of the wire into the center of the connected bottom, from the inside of the insert a button of a suitable diameter (this is for fastening), twist the ends of the wire together and wrap with adhesive tape.




This design takes time, but it is very reliable and attractive from the outside: a 
beacon for scissors 

Buds with different fastening options 







Freeform - petals: 3 pieces for each flower 
3-4 in to close into a ring; or start with a loop of amigurumi 




1 row: 1vpp, 6 sbn in a ring, 8 psn for the rear half loops (2 psn in 1 loop); 
10 ssn for rear half-loops (2 ss in 1 loop) = curl; The thread does not break off! 
2 row: we continue to knit working thread: (kulechek, 1 para) x 5 times, 11 twisted columns; 
Row 3: without turning the knitting, lift the maximum possible number of loops under the bags (I have 11 loops) and knit several rows with Tunisian knitting, reducing it to naught.
4th row: knit connecting posts to its base along the left edge of the resulting triangle. Without turning the knitting, return in crayfish steps to the apex of the triangle, and then on the right side up to the twisted columns. 
5 row: 1 wl, (concave ssn + 1 wp) x 11 times, kn, turn the knitting face down. 
6 row: 1 w, 1 entwined pillar in the girth of the legs of each of the concave csn of the previous row, sbn, 1 w. 
7 row: smoothly "crawl" ss or vp to the free half loops of the curl and tie on them a thrill step in the direction of the center. Fasten the thread and thread from the wrong side. Leave enough tail for sewing. 
In the pictures it looks like this: 




Place the finished petals on the bud. Attach each petal with one pin for the top,
and with the help of another - at the base. 
If you are satisfied with the arrangement of the petals, then we sew each petal 
to the bud along the perimeter (a semicircle of twisted columns) with inconspicuous stitches , leaving the corners of Tunisian knitting not sewn. 
Remove pins. Corners themselves beautifully wrapped out. 

Leaf knit arbitrarily or according to any of the proposed schemes. 
At the same time, we take into account that the leaf should not draw attention to itself! 
Therefore, we knit it monotonous, small in size and simple in pattern. 










Rope-string for the beacon: we 
knit a chain of air loops of the desired length (I have 60 points) and tie it with connecting bars. 
You can start and end the chain directly from the bottom of the bud.
By the way, I tried to knit a cord-caterpillar, but at such sizes it looks too thick. 
The combination of tulips with a caterpillar cord would be appropriate if you use them as bag decoration 
(a similar analogue of brushes or pompons) or for a children's or summer backpack - in this case the cord 
will be used for its intended purpose - to tighten the backpack, and the tulips at the ends of the cord are an ornament. 

Sewing or tying leaf. Tulips are ready! 










They can be used as beacons for scissors 
As pendants for a phone or a key ring 




And a smart photo of 







Source : https://www.liveinternet.ru/users/sama_lubov/post392455783/







Post your comment

Information!  You need to be a member to comment. You can easily sign up from here.

0 comments