Density of knitting
26 p. x 38 R. = 10 x 10 cm, connected facial surface with openwork pattern on the spokes № 3
Attention!
The density of knitting should correspond to the given, and first of all-on width.
If only one number is specified in the instruction, it applies to all dimensions!
Performing work
Back
On the Spokes № 3 Dial 146 (154) 166 p. and knit for the bottom Strap Rubber Band (1st row = IPMs. series).
After 6 cm The knitting gum finish iznanochnym Next and the next front row to knit facial, with evenly decreasing loops to the spokes left 123 (133) 143 p.
Continue the work with openwork pattern on the scheme.
When the backrest length is 45 cm, make on both sides for a armholes mark.
To form a armholes close on both sides at the beginning of each row of 4, 3, 3, 2, 1, 1, 1, 1 (4, 3, 3, 2, 2, 1, 1, 1, 1) 5, 4, 3, 2, 2, 1, 1, 1, 1 P. = On the Spokes 91 (97) 103 p.
When the height of the armholes from the marks is 20 (21) 22 cm, Close for the neck medium 41 (43) 45 p. And both sides to finish separately.
To round the neck close from the inner edge at the beginning of each row 3, 2 p.
At the same time for the shoulder bevel to close from the outer edge at the beginning of each row 6, 7, 7 (7, 7, 8) 8, 8, 8 loops.
Before
Knit like a back, but with a deeper neck.
When it remains to tie the last 12 cm (= until the last closed loops of the shoulder bevel on the backside), close the Middle 19 (21) 23 p. and both sides to finish separately.
For rounding of a neck to close from an internal edge at the beginning of each row first 4, 3, 2, 2, 1, 1, 1 p., then another 2 times on 1 p. At the beginning of each 2nd row.
Dovjazav to the 1st closing of the shoulder bevel loops (check on the backside), the shoulder loops close similarly.
Sleeves
On the Spokes № 3 Dial 74 (78) 82 p. and knit a rubber band as described for the backrest.
After 12 cm The knitting gum finish iznanochnym Next and the next front row to knit facial, with evenly reduce loops to make the spokes were 61 (67) 73 loops.
Continue the work with openwork pattern on the scheme.
For bevels to add on both sides on 1 p. (after/before edging) in each 8-th R., until the spokes will not be 85 (91) 97 p.
When the length of the sleeve is 43 (44) 45 cm, start forming okat: At the beginning of each row first close on both sides of 3, 2 p., then execute decreases: in persons. Row 1 P. To bind, 2 p. Knit together, knit to the last 3 pi on the spoke, 2 p. To knit together with the inclination to the Left (= 1 p. Remove, the next loop to knit and removed the loop to stretch through the knitted), 1 p. to untie. These decreases repeat in every 2nd person. Number-only 7 times, then continue in each person. Number until the spokes remain 41 (43) 45 p.
After that close on both sides at the beginning of each row another 2, 3, 4 p. and the remaining loops close in one row.
Assembly
Shoulder, side seams and seams. Sew sleeves so that the Barcelona not formed folds.
For Baikie to dial on the edge of the neck from the front of the work on the circular spokes № 2.5 loops: Start from the right shoulder seam and dial on the edge of the neck of the backrest to 1 p. of each closed loop + 3 p. (distribute evenly) for each rounding. On the direct section of the left hand to dial 1 p. From each row, skipping every 6th p. If it was closed on 1 p., to dial on 1 p. From each closed loop and additionally on 1 p. Between closed loops. On other edges with closed loops to dial on 1 p. from each closed loop. On the other side of the loop dial similarly. The number of loops must be a multiple of 4.
Knit in a circle elastic band = alternately 2 persons., 2 IPMs., when the width of the Baikie is about 4 cm, the hinges close.