Click For Crochet Abbreviations List

Coat with a hood trapezoidal silhouette tied at the fork. 

Coat size: 36-40

You will need: 1300 g of turquoise yarn Basso (100% wool, 32 m / 100 g); 2 universal forks; hook number 10; 2 stud buttons; crepe tape.

Fork width: 16 cm.

On 2 crossbars of both forks, push each other so that the external holes between the teeth are 16 cm apart from each other. The bars in the middle tightly wrap crepe tape. Insert the teeth of one fork into the outer holes; the teeth of the second fork will not be required. After the right loop is made on the right prong (step 1, below), put the 2nd wrapped cross bar over the teeth.

Knitting borders:

Step 1: make a crochet hook an initial loop with a length of 8 cm. Put the loop on the right tooth, (see fig. 1).

Step 2: hold the working thread behind the fork, the initial thread (and subsequently the hem) to hold with the thumb and middle fingers of the left hand. Turn the plug 1 time from right to left, the working thread forms a loop on the as long as the free tooth, it is now located on the right. Hook to enter into the left loop from front to back, grab the thread and tie 1. n. (see fig. 2). 

Step 3: put the hook vertically hook down, insert the right prong through the plug (see. Fig. 3). Turn the plug 1 time from right to left, thus forming a new loop, which after turning is located on the right tooth, the hook is again located in front.

Step 4: enter the hook from front to back under the front thread of the left loop, grab the thread and tie 1 tbsp. b / n (see fig. 4). Steps 3 and 4 are repeated until the number of loops on each tooth specified in the instruction is received.

The connection of parts of the rim: one border to expand so that the loops of one edge were directed upwards. The 2nd border is applied parallel to the top. Connect 2 loops of one border 1 tbsp. b / n, while on the bottom hem insert the hook into both loops from the front to the right and output from the back to the left, the loops are not twisted. On the top hem, insert a hook into both loops in the front left and out in the back right, here the loops are twisted at the base. Between connecting art. b / n in accordance with the instructions to perform 1 or 2 air. P.

The density of knitting borders: on a fork, the width of each border = 16 cm.

After crocheting and joining, the border is 14.5 cm wide.

5.5 loops = height 10 cm (measured after removing from the plug in the middle of the rim).

Attention: the back and the shelves before the armhole should be made with a single cloth from the parts of the border located across. Then finish back and shelves separately. For sleeves, connect 4 edges each.

Back and shelves: for the bottom of the coat, tie 1 border of 78 loops, cut the thread and stretch through the last n. Kayma remove from the fork. The 2nd border of 68 loops, the 3rd border of 62 loops and the 4th border of 56 loops are similar. Lay out the 1st border in such a way that the loops of one edge are directed upwards. The 2nd border is applied parallel to the top. The first 2 loops of the 1st border connect 1 tbsp. b / n, 1 rev. p., then the first 2 loops of the 2nd border connect 1 tbsp. b / n, 1 rev. p., * the following 2 loops of the 1st border connect 1 tbsp. b / n, 1 rev. p., the next 2 loops of the upper border connect 1 tbsp. b / n, 1 rev. p., from * repeat, but for a trapezoid silhouette on the 1st border, tie 10 x 3 loops instead of 2 loops evenly.

Attention: the reductions on the pattern are depicted as bevels. Put the 3rd border in parallel on the 2nd border and connect them in the same way, but for the trapezoidal silhouette on the 2nd border, tie 6 x 3 loops evenly. Connect the 4th border with the 3rd border in the same way, and also tie together 6 x 3 loops.

Distribute the top edge of the coat as follows: the first 15 loops form the right shelf, the middle 26 loops form the back, the remaining 15 loops form the left shelf. For the upper part of the right shelf, tie 1 border of 14 and 12 loops. With the first 15 loops of the 4th hem of the coat, join the hem of a shelf of 14 loops, as before, while knitting the coat together 1 x 3 loops in the middle of the hem. Then attach the hem of a shelf of 12 loops, while at the beginning and at the end knit together 3 loops of the previous hem. The upper part of the left shelf to perform similarly. For the upper part of the back tie 2 borders of 24 loops. With an average of 26 loops on the 4th hem of the coat, join the hem of the back, while evenly knotting together 2 x 3 loops of the hem of the coat. To combine the 2nd border with the previous one.

To fasten the edges knit as follows: start from the top corner of the right shelf and for the shoulder seam connect the first 2 loops 1 tbsp. b / n, * 1 rev. p., the next 2 loops connect 1 tbsp. b / n, from * repeat 4 more times, then move to the back. For the 1st shoulder seam, knit 6 x 2 back loops with the vents between them. p., then for the seam pritachivaniya hood to perform 5 air. Clause 1 of Art. b / n in the middle of the border and 5 air. p., then for the 2nd shoulder seam, knit 6 x 2 loops with spaced air between them. p., go to the left shelf and perform shoulder seam, like the right shelf.

Note: the hinge-stitching hinges are additions that extend the upper hem of the back in the middle. This pattern is not taken into account. After tying the left shoulder seam to perform for the side of the left shelf 5 vozd. Clause 1 of Art. b / n in the middle of the upper border, * 5 air. Clause 1 of Art. b / n in the next connecting p., 5 air. Clause 1 of Art. b / n in the middle of the next border, from * to the bottom edge, repeat, finish 5th. p. Then to fix the bottom edge * connect 2 loops 1 tbsp. b / n, 2 rev. p., from * repeat, finally concatenate 2 loops 1 tbsp. b / n Onboard the 2nd shelf to tie the board 1th shelf symmetrically. Check Out 1 Comm. in the initial paragraph

Sleeves: tie the 1st border of 14 loops, the 2nd border of 16 loops, the 3rd border of 18 loops and the 4th border of 16 loops. Lay out the 1st border in such a way that the loops of one edge are directed upwards. The 2nd border is applied parallel to the top. The first 2 loops of the 2nd border connect 1 tbsp. b / n, 1 rev. p., then the first 2 loops of the 1st border join 1 tbsp. b / n, 1 rev. p., * the following 2 loops of the 2nd border join 1 tbsp. b / n, 1 rev. p., the next 2 loops of the 1st border connect 1 tbsp. b / n, 1 rev. p., from * repeat, at the end of the last 2 loops of the 2nd border to knit together. Lay the 3rd border in parallel on the 2nd border and connect in the same way. Lay the 4th border in parallel on the 3rd border and connect in the same way, but start and finish with connecting loops on the 3rd border. For okat, tie the top edge of the 4th border as follows: connect the first 2 loops with 1 st. b / n, * 1 rev. P., the next 2 loops connect 1 tbsp. b / n, from * repeat until all loops are knitted. To fasten the bottom edge of the sleeves, tie the open edge with the loops of the 1st border in the same way.

Hood: tie 1st border of 28 loops, 2nd and 3rd border of 32 loops. Lay out the 1st border in such a way that the loops of one edge are directed upwards. The 2nd border is applied parallel to the top. Connect the 2nd border with the 1st border, while simultaneously knitting together 4 x 3 loops of the 2nd border. Then connect the 3rd border with the 2nd border. To grind the seam, fold the hood in half with the front side facing inwards and connect 1 x 4 loops (2 for each half) in the middle of the backrest 1 tbsp. b / n, then connect 14 x 1 loop located in the front and in the back half of 1 tbsp. b / n

To fasten the bottom edge of the untight loops of the 1st border knit as follows: * 2 loops connect 1 tbsp. b / n, * 1 rev. p., the next 2 loops connect 1 tbsp. b / n, from * repeat until all loops are knitted.

Assembly: perform shoulder seams. Sew the middle 17 cm of the lower edge of the hood to the back seam of joining the hood, while slightly seating it, sew the remaining 17 cm on both sides to the upper 17 cm of the edges of the shelves. Stitch the sleeves, with the upper edge and the ends of the 4th border stitch, like an okat, in the armhole, on the lower 3 hems to complete the seam of the sleeve. Sew buttons to the left shelf at a distance of 3 cm from the edge to the connecting row of the 5th and 6th border, as well as to the middle of the 5th border.

Pattern and knitting technique on the fork: