An interesting and very unexpected combination of patterns, lightweight yarn made of cotton and flax and a style “balloon” make this model very attractive.
Yarn (60% cotton, 40% flax; 260 m / 100 g) - 500 g blue; Knitting needles number 3; circular needles No. 3 with a length of 40 cm; hook number 3; 3 black round buttons with a diameter of 10 mm.
Alternately 1 person. crossed, 1 out. In purl rows, the loops are knitted according to the pattern, but the facial loops are knitted with the front ones crossed.
Alternately, 1 p. Of the front surface, 1 p. Of the ream surface, shift the pattern by 1 p. In each row.
Knit according to the above schemes A and B. Knit 1 time rapport = 12 p. Always repeat 1–10th p in height.
Openwork pattern with rubber band
Knit according to the above scheme S. Rapport = 4 items distributed according to the description in the instructions.
In height constantly repeat 1-4th r. In the purl rows, knit 2 nakida of the previous row as follows: 1 purl and 1 purl crossed loop.
MIDDLE openwork pattern
Knit according to the above scheme D. Distribute the loops according to the description in the instructions.
Proceed at the height of 1–8th p., Then constantly repeating the 5–8th p., With each repetition perform more by 1 rapport, shown on the gray substrate between the arrows = 4 points of increase with each repetition of the rapport .
LEFT AND RIGHT
Knit according to the above schemes E and F. Distribute the loops as described in the instructions. In the height of 1 time knit 1-52 th p.
KNITTING DENSITY
18 p. X 26.5 p. = 10 x 10 cm, connected with the front surface of the spokes No. 3;
“Spit” A or “Spit” B - 12 p. X 26.5 p. = 4 x 10 cm.
ATTENTION!
Due to its weight when worn, the dress is pulled out in length. The openwork pattern is also very elastic. Measurements from an openwork pattern and measurements for the pattern were taken from the model lying on a horizontal surface.
Pattern
COMPLETING OF THE WORK
BACK
On the knitting needles, type 88 p. And knit 4 cm = 10 p. For the slat. rubber band.
Then distribute the loops as follows: 1 edge, 29 p. Of the front smooth surface, 12 p. Of the “braid” A, 4 p. Of openwork pattern with an elastic band, 12 p. Of the “spit” B, 29 p. Of the front smooth surface, 1 of the edge.
Through 4.5 cm = 12 p. from the strap, distribute the loops as follows: 1 edge, 5 p. of the front smooth surface, 12 p. of the “braid” A, 12 p. of the front smooth surface, 12 p. braids "B, 12 p. of the front smooth surface, 12 p." spit "B, 5 p. of the front smooth surface, 1 edge.
For bevels in the hips through 5.5 cm = 14 p. From the plank add 1 x 1 p. and then on both sides add in each 6th p. 6 x 1 p. = 102 p.
Для приталивания еще через 13,5 см = 36 р. от последней прибавки с обеих сторон убавить 1 х 1 п., в каждом 8-м р. 5 х 1 п. и в следующем 6-м р. 1 х 1 п. = 88 п.
Одновременно через 41,5 см = 110 р. от планки провязать вместе первые 2 лиц. после первой «косы» А лицевой с наклоном влево и последние 2 лиц. перед второй «косой» В провязать вместе лицевой = 86 п.
Эти подчеркнутые убавки выполнить аналогично еще 3 раза в каждом 6-м р. = 80 п.
Через 48 см = 128 р. от планки на средних 4 п. начать средний ажурный узор, перед ним и после него начать убавки: перед средним ажурным узором по схеме Е и после среднего ажурного узора по схеме F. Для пройм с обеих сторон закрыть петли, как показано на схемах Е и F.
For neckline through 38 p. = 18 cm from the beginning of the middle openwork pattern, close the average 20 points, while making sure that the number of nakida and knitted loops on internal rapport coincide, and first finish the left side.
For rounding the cutout on the inner edge in each 2nd p. close 2 x 3 p., 1 x 2 p. and 2 x 1 p. = 40 p.
After 6 cm = 12 p. from the beginning of the neckline close the remaining hinges.
Perform the other side symmetrically.
BEFORE
Knit like a back, but for a deeper neckline averages 12 s. Close in 32 p. = 15 cm from the beginning of the middle openwork pattern and finish both sides separately.
For rounding the cutout on the inner edge in each 2nd p. close 2 x 3 p., 1 x 2 p. and 6 x 1 p., while making sure that the number of nakida and knit stitches on internal rapport coincide.
SLEEVES
On the knitting needles, dial 42 p. And knit 6 cm = 16 p. For the slat. gum, then knit openwork pattern. At the same time between the edge constantly repeat rapport.
For bevel sleeves on both sides, add in the 17th p. from the strap 1 x 1 p. and in each 16th p. 3 x 1 p. = 50 p. The
added loops should be gradually included in the openwork pattern, while ensuring that the number of nakida and knit stitches coincide on the external rapport.
For okat through 38 cm = 79 p. from the bar on both sides close 1 x 2 p. and in each 2 nd row 9 x 1 p. and 1 x 2 p. = 24 p.
Through 10 cm = 22 p. from the beginning of okat close the remaining loops.
ASSEMBLY
Run shoulder seams.
According to the circular knitting needles, dial 102 points, at the same time, start and finish from the middle of the back and distribute the loops as follows: 1 edge, 2 points of small pearl pattern, * 3 points of seamy finish, 3 points of front face, * constantly repeat, 2 s. small pearl pattern, 1 edge. In the next 10th row in each purl, knit together 2 res. = 86 p. Through 7 cm = 16 p. all loops close.
Sew sleeves. Run side seams and sleeve seams. Spread them evenly, sew buttons on the loops of the left-sided pearl pattern on the strap of the fastener. For 3 hinged buttonhole loops, follow the chain of 10 inc. and sew in front of buttons.
Source :
http://vovkyse.ru/post428334614/